Description:
Thermo Scientific Thermolyne F47920-33-80 120 cu in Benchtop Muffle Furnace with C1 Controller, 240V EU Plug. It is ideal for general laboratory use, including gravimetric analysis, sintering, quantitative analysis and heat treating. It reaches a 1200°C maximum temperature and is available in two capacities for added flexibility. The built-in vent port removes contaminants and moisture to extend the life of the heating element and furnace. Open coil heating elements on both sides of chamber assure fast heat-up, with minimum temperature gradient. Maximum energy efficiency is achieved by surrounding the chamber with thermal-efficient ceramic insulation. The rear of the chamber includes a chamber monitoring port for independent temperature measuring device monitoring. Built-in venting system removes undesirable contaminants and moisture and extends the life span of the element and unit. C1 - Programmable with one (1) stored program of eight (8) segments. Each segment includes one ramp and one dwell, so you can program 8 ramp/dwell cycles. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. An LED display simultaneously shows both setpoint and actual furnace temperatures. A mechanical over temperature protection relay and RS-232 communications interface are also included. 240V EU Plug.
- Capacity: 120 cu. in. (2 LT)
- Maximum Temperature: 1200°C (2192°F)
- C1 Digital programmable control with one stored program of eight segments
- Chamber Dimensions (W x H x L): 5" x 4" x 6" (13.7 x 10 x 15 cm)
- Exterior Dimensions (W x H x L): 11.3" x 18.5" x 15.5" (28.5 x 47 x 39 cm)
