Description:
Thermo Scientific Thermolyne F47920-33 120 cu in Benchtop Muffle Furnace with B1 Controller, 240V EU Plug. It is ideal for general laboratory use, including gravimetric analysis, sintering, quantitative analysis and heat treating. B1 - Single setpoint with one ramp and one dwell. The ramp is used to vary the heat-up rate to your specified setpoint. The furnace will then dwell (hold the temperature) at a set level for a specified time. Single display shows actual temperature or setpoint. A mechanical over temperature protection relay is also included. It reaches a 1200°C maximum temperature and is available in two capacities for added flexibility. The built-in vent port removes contaminants and moisture to extend the life of the heating element and furnace. Open coil heating elements on both sides of chamber assure fast heat-up, with minimum temperature gradient. Maximum energy efficiency is achieved by surrounding the chamber with thermal-efficient ceramic insulation. The rear of the chamber includes a chamber monitoring port for independent temperature measuring device monitoring. Built-in venting system removes undesirable contaminants and moisture and extends the life span of the element and unit. This furnace is available with four different controllers allowing various levels of control and programs. All of the controllers are digital. Operating Temperature: 100° to 1200°C. Shipping Weight: 41lb. 240V EU Plug.
- Capacity: 120 cu. in. (2 LT)
- Maximum Temperature: 1200°C (2192°F)
- B1 Digital single set point control with a single ramp to set point and a dwell
- Chamber Dimensions (W x H x L): 5" x 4" x 6" (13.7 x 10 x 15 cm)
- Exterior Dimensions (W x H x L): 11.3" x 18.5" x 15.5" (28.5 x 47 x 39 cm)
