Buret Clamps

Photo of Polypropylene Burette Clamps
These non-corroding, polypropylene burette clamps do not obscure graduations. Burette is held firmly in place by rubber pads and a concealed steel spring. Center clamp tightens to a standard support rod; 12.5mm (1/2") and 9.5mm (3/8") bushings included.
Photo of Round Jaw Coated Buret Clamp
Clamp has Plastisol-coated jaws that rotate 360° and may be locked at any angle by checknut. Stamped steel with zinc plating. Length 6⅜" (162mm) jaw opening ⅜" (10mm) to 1⅜" (35mm).
Photo of Round Jaw Buret Clamp

Stamped steel with zinc plating. Jaws rotate 360° and may be locked at any angle by checknut. Length 6⅜" (162 mm), jaw opening ⅜" (10 mm) - 1⅜" (35 mm).

Photo of Lincoln Type Double Buret Clamp
Fitting on 5/8" (16mm) support rods or smaller, this stamped steel clamp is zinc plated for corrosion resistance and has a steel thumbscrew. The clamp is 9" (229mm) long by 3" (76mm) wide with a center distance 7-1/4" (184mm) between burettes. The unit is designed for use with burettes from 6mm to 16mm in diameter.