Angled Adapters

Photo of Corning 8947-14 PYREX® 105° Angle Vacuum Connecting Adapter

These PYREX® 105° angle vacuum connecting adapters have a tubulation of 10mm O.D. for attaching to a vacuum pump and inner and outer 14/20 Standard Taper joints. Includes a drip-tip on the inner tube. These tubes are also replacement parts for organic chemistry kits No. 6949K.

(Sample Photo Displayed. Individual items may differ from the image shown.)

 

Photo of Corning 8920-24 PYREX 75° Angled Tube Adapter

The arms are approximately 75° apart and both are equipped with inner TS joints of the same size. Often used as a stillhead adapter.

(Sample Photo Displayed. Individual items may differ from the image shown.)

 

Photo of Corning 8840-24 PYREX 105° Angled Tube Adapter with Single 24/40 ST Joint

The arms are approximately 105° apart. The upper end is equipped with an outer ST joint. The lower end is cut off at an angle and is used as a receiver adapter. Tube O.D. is 12mm.

(Sample Photo Displayed. Individual items may differ from the image shown.)

 

Photo of Corning 8946-24 PYREX 105° Angle Vacuum Connecting Adapter
With outer ST joint at the top and an innersealed through driptip joint at the bottom. Bent at a 105° angle. The serrated sidearm is 10mm O.D. Driptip at the bottom extends about 20mm below the lower end of the joint.
Photo of Corning 8950-24 PYREX 60° Angle Distilling Connecting Adapters

These PYREX® 60° angle distilling connecting adapters have a 24/40 outer joint at the upper end and inner 24/40 joints and on the sidearm and lower joints. This tube is also a replacement part for organic chemistry kit No. 6949.

(Sample Photo Displayed. Individual items may differ from the image shown.)